Переведите на русский язык в письменной форме абзацы 1,2 и 5.
5. Найдите соответствующие ответы на вопросы и напишите их в той последовательности, в которой заданы вопросы:
Вопросы
1. By what properties are metals distinguished from nonmetals?
2. What common metals are produced in great quantities?
3. What metals are called light?
4. What properties do nonmetals have?
5. What is done to protect metals from corrosion?
Ответы
a. Iron, copper and zinc.
b. They are usually poor conductors of heat and electricity.
c. They are coated by some organic coatings,
d. High conductivity for heat and electricity.
e. Aluminium, berillium and titanium.
6. Закончите предложения, выбрав соответствующий вариант окончания:
There are some different groups of metals, such as:
1. light metals a) iron, copper, zinc.
2. common metals: … b) silver, gold, platinum
3. precious metals: ... c) aluminium, berillium, titanium.
4. Nonmetals are… a) carbon, silicon, sulphur
b) aluminium, berillium, titanium.
Вариант 4
1. Найдите в правой колонке русские эквиваленты слов и словосочетаний:
1 engine lathe a. задняя бабка
2. turning b. фартук (суппорта)
3. drilling c. каретка
4. screw cutting d. передняя бабка
5. headstock e. сверление
6. tailstock f. токарно-винторезный станок
7.saddle g. нарезание винтов
8. lever h. рычаг
9. apron i. рукоятка
10. carriage j. суппорт
11. guideways k. обточка
12. handle l. направляющие (станка)
2. Переведите на русский язык встречающиеся в тексте интернациональные слова:
metal, operation, principal, spindle, function, centre, control, base, special, bolt.
1. gearbox and headstock; 2. tailstock; 3. frame; 4. spindle; 5. feed gearbox;
6. electric motor; 7. control panel; 8. cross slide, 9. carriage; 10. tool block; 11. ways;
12. lead screw; 13. feed rod; 14. operating lever shaft; 15. operating and reverse handle;
16, apron; 17. hand feed wheel
3. Простите текст и выполните следующие за ним упражнения:
ENGINE LATHE
1. The engine lathe is the most commonly used machine-tool. It is used ; variety of metal operations, such as turning, drilling, screwcutting and many others.
2. The principal units of the lathe are the bed, the headstock, the tailstock and the carriage with the apron
3. The bed is the base of any machine-tool and it is made of grey iron on which the saddle and the tailstock slide along special guideways. The headstock is also located and bolted on the bed.
4. The headstock contains the spindle and the speed gearbox. The spindle is the part of the machine to which power is applied to rotate the work. The changing of the spindle speed is effected by levers.
5. The tailstock consists of a casting fitted to the bed. The function of the tailstock is to support one end of the work turned between centres and to mount the tools.
6. The carriage of the lathe, which carries the tool, is made up of two principal parts: the saddle and the apron. The saddle travels along the guideways of the bed. The apron represents the front wall of the carnage. On the front of the apron are mounted the handles and levers by which the actions of the tool are controlled.